Page 185

Hytek Catalogue Retail 2013-14

Heating Oil & Fuel Tank Equipment Hytek Leak Detection Kit A simple to install & easy to use ‘Secondary Containment’ pipe leak detection system. It works by sealing the outer ‘Secondary Containment’ pipe & the inner ‘Product’ pipe together. The join between the two pipes is then monitored using a float switch sealed into the sensor housing, fitted below the height of the join. Any fuel that leaks will activate the float switch which is connected to a 230V alarm (Float switch not included with LS.KIT). Sensor housing kit (LS.KIT) - 1m of connector tube c/w valve & clip (fits onto the pipework). - Sensor housing pot must fit below the pipework (float switch fits inside). - Mounting bracket (fits to the chamber wall). Also required alarm box & float switch - 230V alarm box c/w flashing beacon & sounder (TA2.POW). - Float switch comes with 5m of cable (TA.F5). - For more information on this alarm see pages 178 - 179. Please note The connector valve on the end of the tubing should be connected to the test port on the secondary containment termination boot (this is for pipework leak detection only). If no secondary containment termination boot is used, the valve, tubing & gland that fits onto the sensor housing pot should be removed completely, allowing the pot to fill up, activating the float switch & alarm. If only 1 chamber & 1 sensor housing kit are to be used then they should be mounted in the lowest point of the pipework run. LS.KIT Engineered Product TA2.POW GP.CONKIT CHAMB.650 Stk Code Description List LS.KIT Sensor housing kit 110.77 TA2.POW 230V alarm box 204.85 TA.F5 Float switch 41.00 Cable Encapsulation Kit - Buried cable wire splice encapsulation kit. - Use to connect cables within below ground chambers & ducts. - Kit consists of barrel & sleeve, end caps & water resistant encapsulation compound. Connects up to 5 pairs of cables. Stk Code Description List GP.CONKIT Cable encapsulation kit 25.35 Underground Connection Chambers - These solid bottomed GRP chambers are ideal for providing accessible connection or termination points for all buried pipe, as recommended in OFTEC TI/134. - Comes complete with a non-load bearing cover & gasket. H Stk Code Description List CHAMB.650 650mm sq. chamber & lid 427.52 Copyright HYTEK (GB) LIMITED 2013 185


Hytek Catalogue Retail 2013-14
To see the actual publication please follow the link above